Little jobs

With a couple of exhibitions last month, progress with the Rail200 challenge has been interrupted, but I have continued with the buildings when time allowed. There were some final additions to make.

I've had a Ratio boiler house kit in the stash for a long time, from a long forgotten project, so I thought I'd use the nice metal chimney on my boiler house. The base in the kit is stone, so I cut one from Wills brick but cut out the ash doors and fitted them into the brickwork. 

The base is sized to maximise chimney height within the limit. Really, a much taller (and more grand) chimney would be more appropriate, but won't fit, and I figured a chimney makes it look less like a goods shed. Perhaps it's for an auxiliary boiler? 

The Ratio boiler house also provided a sprue with "sleepers", which I used to make a small coaling stage just outside the engine shed. There were just enough sleepers! More Wills brick forms a low retaining wall around it. 

The inside of the rear wall of the engine shed will be visible, so I cut an inner wall from thinner Slater's brick to fit after installing the windows.

The engine shed and boiler house will use doors from the Wills engine shed, I thought for a while about how to fit them. The instructions suggested making wire loops as hinges, which sounds fiddly. I decided to drill 0.7mm holes in the top and bottom edge of the door, with a vertical wire to fit a hole in a lip behind the lintel and an L-shape wire at the bottom to fit in a hole in the side of the doorway. In theory, this will allow then to open and close - but if they can be fixed open I'll be happy. 

Floors for the buildings were cut from grey card, which I find an easy way to represent concrete. Paper templates were used, cut to the building shape then pressed onto the rails to mark their position.

Here's the boiler house floor in place with a 14mm wide strip between the rails. The underside of the edge of the outer pieces is chamfered slightly to sit low on the chairs, the surface needs to be below the rail top.

Finally, at Chatham I was looking for pre-nationalisation general purpose wagons for the layout. I thought the one in the Mainline box was a good deal, until I found another stand with 4 loose wagons for £10. They might need some touching-up, three are without coupling but I'd be changing them anyway, one even has compensation. The wagons will have to wait for attention though, painting of the buildings is now well underway and there is a lot to do to get the layout looking finished.