The first photo shows the fitting of the point motors and uncoupling magnets for the micro-trains couplers I use. For these the magnetic field has to be accross the track, and I have found that a pair of cupboard-catch magnets works well. They are available in bulk from B&Q or Homebase etc., and are easily dismantled to get the magnets out. These are stuck together and glued into an oblong hole I cut into the baseboard before laying the track (the holes were covered in paper and the track layed over the top).
The point motors are SEEP - with a built-in accessory switch I will use for the point frog polarity. I simply glue these to the underside of the board using Bostik, ensuring the operating rod is through the tie bar, the travel of the point motor is parallel to the tie bar and that the range of travel is cental to the point motor (important for the switch to operate). Here I have stuck the point motors to pieces of thin corrugated card stuck to the board, partly as the plywood was uneven where it had been drilled, and partly hoping to reduce noise - we shall see!
The second picture is the control panel I have just made. For such a small layout it is suprising how complex the wiring is! There are 7 point motor switches (silver), 4 main track feeds and 3 further isolating sections (with coloured caps to match the diagram). I was concerned that I would not fit them all in the space I had cut out of the front of the baseboard - but fortunately they just fit. The panel is an offcut of metal sheet from the scrap bin at work, drilled on a pillar drill in a lunchtime! The diagram is drawn on a computer (Word, nothing fancy) and printed out, stuck to the metal with Bostik. Finally a layer of clear plastic (the bubble pack from a Wills kit) is laid over the top, and the switch holes cut out with a scalpel.
I wanted the panel to be recessed into the cut-out in the baseboard, and it will be held there with a couple of M4 bolts, however access behind the cut-out is very difficult because of the board bracing! Still, it will look good.
Now I have started the actual wiring, so the next update should be when that is finished. I won't have much time in the next couple of weeks though, so progress may be slow!
If you are interested in model railways, particularly in narrow gauge, or small (micro) layouts, then I hope you will find this site interesting. I try to update it periodically with news of my current models and layouts, and anything else model-railway related (and sometimes not!). I usually model in 009 scale (1:76 or 4mm/ft using 9mm gauge track), although I have recently dabbled in 014 (1:43 or 7mm/ft on 14mm gauge track) as well. For more on my current and past layouts click the the links to the pages below. If you have any comments or feedback, do let me know!
I have been building model railways since I was a teenager, mostly in 009 scale though I have also worked in 00, and more recently 014.
I am a member of the 009 society (which is highly reccommended if you model in 009 or similar) and of the local area group of the society in Sussex, the Sussex Downs group.
Away from model railways, I am a chartered engineer working in the automotive industry, I am married with two small children to occupy most of my free time, and I am involved in the PA and technical things at my church. So I don't get a lot of time for model railway building!